3.2
Owner's of the VTech Cordless Telephone DECT gave it a score of 3.2 out of 5. Here's how the scores stacked up:
4
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below). If necessary, place the handset in the telephone base or charger
to charge the battery. For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after 10 hours of
continuous charging. See the table on page 50 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 30 minutes to give the handset enough charge to use the telephone for
a short time. When the battery is low, the handset plays four short beeps and
shows LOW BATTERY along with a flashing icon. When you are on a call in
low battery mode, the handset plays four short beeps every 50 seconds.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank,
or shows PLACE IN
CHARGER and flashes.
Battery has no charge
or very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
LOW BATTERY and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption (at
least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
Getting started
If you place the handset in the telephone base or charger without plugging in a
battery, the screen displays NO BATTERY.
After you install your telephone or power returns following a power outage, the
handset will prompt you to set the date and time. For instructions, see
Set date and time on page 14. To skip setting the date and
time, press OFF/CANCEL.
SET DATE
--/--/--
Find Your Products By Category
Please Login
