Bostitch Nail Gun Bostitch Angled Finish Nailer User Manual

4.0

Out of 1 Ratings

Owner's of the Bostitch Nail Gun Bostitch Angled Finish Nailer gave it a score of 4.0 out of 5. Here's how the scores stacked up:

  • Reliability

    4.0 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    4.0 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.0 out of 5
of 49
 
-8-
LOADING THE TOOL
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side
shielded spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
•Neverplaceahandoranyotherpartofthebodyinnaildischargeareaoftoolwhile
the air supply is connected.
•Neverpointthetoolatanyoneelse.
•Neverengageinhorseplay.
•Neverpullthetriggerunlessnoseisdirectedatthework.
•Alwayshandlethetoolwithcare.
•Donotpullthetriggerordepressthetripmechanismwhileloadingthetool.
LOADING THE BTFP72155/BTFP72156
The BTFP72155/BTFP72156 nailers are equipped with dual load purpose magazines. Nails can be loaded
in either method.
LOAD AND PULL PUSHER
1. Load nails through the slot in the rear of the magazine to past retaining clip.
2. Pull pusher back behind nail stick and release.
3. Ensure magazine pusher is behind the last nail stick.
4. Blow the magazine clean periodically to keep the pusher moving smoothly and to keep dirt and debris
out of the nail channel.
.
PULL PUSHER TO LOCK BACK AND LOAD
1. Pull pusher back until it is locked at the end of magazine.
2. Load nails through the slot in the rear of the magazine and past retaining clip.
3. Press the pusher button to release and allow the pusher to push behind the nails.
4. Blow the magazine clean periodically to keep the pusher moving smoothly and to keep dirt and debris
out of the nail channel.

   Find Your Products By Category