Black & Decker Drill DR560 User Manual

0

Out of 0 Ratings

Owner's of the Black & Decker Drill DR560 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 36
 
Drilling
• Alwaysunplugthedrillwhenattachingorremovingaccessories.Whenattaching
accessories in the drill chuck, it is important to securely tighten the chuck using all three
holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
• Usesharpdrillbitsonly.
• Supportandsecureworkproperly,asinstructedinthesafetyinstructions.
• Useappropriateandrequiredsafetyequipment,asinstructedinthesafetyinstructions.
• Secureandmaintainworkarea,asinstructedinthesafetyinstructions.
• Plugindrill.Make sure switch turns drill on and off.
• Runthedrillveryslowly,usinglightpressure,untiltheholeisstartedenoughtokeepthe
drill bit from slipping out of it.
• Applypressureinastraightlinewiththebit.Useenoughpressuretokeepthebitbiting
but not so much as to stall the motor or deflect the bit.
• Hold the drill firmly with both hands to control its twisting action (figure A).
• Usesidehandleifdrill(DR560)isequippedwithone.
• DONOTCLICKTHETRIGGEROFASTALLEDDRILLOFFANDONINANATTEMPT
TO START IT. DAMAGE TO THE DRILL CAN RESULT.
• Minimizestallingonbreakthroughbyreducingpressureandslowlydrillingthroughthe
last part of the hole.
• Keepthemotorrunningwhilepullingthebitoutofadrilledhole.Thiswillhelpreducejamming.
Drilling In Wood
Holes in wood can be made with the same twist drill bits used for metal or with spade bits.
These bits should be sharp and should be pulled out frequently when drilling to clear chips
from the flutes.
Drilling In Metal
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
Troubleshooting
Problem Possible Cause Possible Solution
• Unitwillnotstart. •Cordnotpluggedin. •Plugtoolintoaworking
outlet.
•Forward/reverseslidernotfully •Pushslidercompletelyto
depressed in desired direction. the left or right.
•Circuitfuseisblown. •Replacecircuitfuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
•Circuitbreakeristripped.  •Resetcircuitbreaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
•Cordorswitchisdamaged. •Havecordorswitch
replaced at Black &
Decker Service Center or
Authorized Servicer.
For assistance with your product, visit our website www.blackanddecker.com for the
locationoftheservicecenternearestyouorcalltheBLACK&DECKERhelplineat
1-800-544-6986.
9

   Find Your Products By Category