Black & Decker Cordless Drill LDX112C User Manual

4.0

Out of 1 Ratings

Owner's of the Black & Decker Cordless Drill LDX112C gave it a score of 4.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 40
 
10
SCREW DRIVING
For driving fasteners, the reversing button should be pushed to
the left. Use reverse (button pushed to the right) for removing
fasteners. When moving from forward to reverse, or vice versa,
always release the trigger switch first.
ON BOARD BIT STORAGE
A bit storage slot (8) is built-in to the area just behind the battery
pack.
DRILLING
•Usesharpdrillbitsonly.
•Supportandsecureworkproperly,asinstructedintheSafetyInstructions.
•Useappropriateandrequiredsafetyequipment,asinstructedintheSafetyInstructions.
•Secureandmaintainworkarea,asinstructedintheSafetyInstructions.
•Runthedrillveryslowly,usinglightpressure,untiltheholeisstartedenoughtokeepthe
drill bit from slipping out of it.
•Applypressureinastraightlinewiththebit.Useenoughpressuretokeepthebitbiting
but not so much as to stall the motor or deflect the bit.
•Hold the drill rmly with two hands to control its twisting action.
•DONOTCLICKTHETRIGGEROFASTALLEDDRILLOFFANDONINANATTEMPT
TO START IT. DAMAGE TO THE DRILL CAN RESULT.
•Minimizestallingonbreakthroughbyreducingpressureandslowlydrillingthroughthe
last part of the hole.
•Keepthemotorrunningwhilepullingthebitoutofadrilledhole.Thiswillhelpreduce
jamming.
•Make sure switch turns drill on and off.
DRILLING IN WOOD
Holes in wood can be made with the same twist drill bits used for metal or with spade bits.
These bits should be sharp and should be pulled out frequently when drilling to clear chips
from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard
oil.
DRILLING IN MASONRY
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but
not so much that you crack the brittle material. A smooth, even flow of dust indicates the
proper drilling rate.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
G
8

   Find Your Products By Category