0

Out of 0 Ratings

Owner's of the DeWalt Automobile Battery Charger DW9057 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 36
 
8
only by the plastic or rubber handle and housing to prevent electric
shock if you saw into a “live” wire.
Metal Cutting (Fig. 7)
This unit has different metal cutting capacities depending upon type of
blade used and the metal to be cut. Use a finer blade for ferrous met-
als and a coarse blade for non-ferrous materials. In thin gauge sheet
metals it is best to clamp wood to both sides of sheet. This will insure
a clean cut without excess vibration or tearing of metal. Always
remember not to force cutting blade as this reduces blade life and
causes costly blade breakage. To prolong blade life, use other areas
of the blade by adjusting the shoe position.
(See Adjustable Shoe,)
NOTE: It is generally recommended that when cutting metals you
should spread a thin film of oil or other coolant along the line ahead of
the saw cut for easier operation and longer blade life.
Wood Cutting (Fig.8)
Before cutting any type of wood, be sure it is firmly anchored or
clamped to prevent slipping. Place blade lightly against work to be cut,
switch on saw motor and allow it to obtain maximum speed before
applying pressure. Always hold saw firmly with both hands while cut-
ting. Whenever possible, the saw shoe must be held firmly against the
material being cut. This will prevent the saw from jumping or vibrating
and minimize blade breakage.
Pocket Cutting (Fig. 9) (Wood Only)
The initial step in pocket cutting is to
measure the surface area to be cut
and mark clearly with a pencil, chalk
or scriber. Insert pocket cutting blade
in blade clamp and tighten blade
clamp securely. Next, tip the saw
backward until the back edge of the
shoe is resting on the work surface.
Now switch motor on, always permit-
ting blade to attain maximum speed.
Grip handle steadily and begin a
slow, deliberate upward swing with
the handle of the saw. Blade will
begin to feed into material. Always be sure blade is completely through
material before continuing with pocket cut.
NOTE: In areas where blade visibilty is limited, use the edge of the
saw shoe as a guide. Lines for any given cut should be extended
beyond edge of cut to be made.
MAINTENANCE
Lubrication
DEWALT tools are properly lubricated at the factory and are ready for
use. Tools should be relubricated regularly every sixty days to six
months, depending on usage. (Tools used constantly on production or
heavy-duty jobs and tools exposed to heat may require more frequent
lubrication.) This lubrication should only be attempted by trained power
tool repair persons, such as those at D
EWALT service centers or by
other qualified service personnel.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local retailer or service center.
English
FIG. 9
FIG. 7
FIG. 8